Recent content by Bandolero

  1. B

    More 6.9 parts for sale........

    I have sold the taillight seals and the badge, but I found a couple of more things for sale. I have a new Starter motor pinion for the 6.9, $60 including postage in Australia. I've also got an oil filter, $30 including postage.
  2. B

    6.9 parts for sale.

    New set of taillight seals. The ones that go between the taillight assembly and the body. $200 inc postage in Australia. New 6.9 badge for the boot lid. $60 including postage in Australia. New interior light dimmer relay for the 6.9. $50 including postage. Rear differential for the 6.9 $1000...
  3. B

    F.S. 15x7 Aftermarket alloys AMG copies with tyres.

    I have for sale four 15x7 (AMG copy) alloys with tyres for sale. $450.
  4. B

    450SEL 6.9 for sale in South Australia

    Hi, I have my Australian delivered 6.9 for sale. It was made in 12/78 and has 350,000 kms on it. It is in good condition and has a host of spare parts that go with it along with a set of aftermarket 15x7 alloys with tyres. The car is fitted with 14" Bundts and new tyres as well. It is red...
  5. B

    AMG Mags (Alloys) for sale.

    Hi all, I'm selling 4 genuine AMG Mags 15 x 7. (No tyres) These are the ones that look like 5 spoke pentas. One mag has a small crack on the lip which can be repaired easily by a wheel specialist. These rims have blue centres and only one AMG cap. (3 missing) $400 plus freight, or nearest offer...
  6. B

    Finally did some needed work on the 6.9!!

    Finally, finally, finally I did some much needed work on my car. Things that needed doing. 1, New indicator stalk as I had to pull back hard on the old one to flash the headlights. 2, New ignition switch as I only had to touch the key and it would switch off....worn out. 3, New interior light...
  7. B

    15 inch steering wheel with OBA large spline Hub.

    I have for sale a 15 inch steering wheel (with steering wheel cover) fitted to an OBA large spline hub ('78 onwards) that is collapsible and ADR approved. (The wheel is branded Luisi.) The wheel was on my 280SE and is great for racing as it is more direct than the standard 17 inch wheel...
  8. B

    Tested out the aircon and cooling on the 280 today>>>>>

    Geez it's HOT!!!!:eek::eek: I was driving around Adelaide today in 42c heat!!:mad::mad: Aircon kept me cool and the coolant never got over 105c. On the freeway home it settled on 95c and when I got home the temp at home was 46c!!!!! So no problems with my cooling and aircon. It certainly got a...
  9. B

    V8 distributor rotors

    Are the 6.9 distributor rotors the same as the 450? I mean the non-rev limiting ones. A friend of mine had a quote from a dealer of over $300 for the 6.9 rotor!! I assume they were quoting for the rev limiter one. Still a ripoff though!! I'm hoping the 450 one will fit?????? I know the...
  10. B

    Fitting aftermarket cruise control?

    I'm sick of the factory cruise control on my 280 forever disconnecting after a few kms even though I have a recon unit from Autohaus. I would like to fit the Auscruise cruise control to it as I've heard they are a good brand to use. Has anyone fitted aftermarket cruise to their 116 and what...
  11. B

    6.9 upper control arms

    I just found out from the dealer that the LH upper control arm is no longer available for the 6.9 but they have plenty of RH side ones. Is the balljoint that is on the control arm able to be reconditioned???? The 6.9 ones are different to the normal 116 as they are stronger and made out of steel...
  12. B

    FS: 1979 280SE in South Aust.

    Hi all, I would like to sell my 280SE as I need to buy a wagon. It is Aussie delivered, has aftermarket CSA mags and sheepskins. (A little old). It has done 320,000kms and has had these parts replaced recently. Waterpump, flex-discs and centre bearing, upper control arms, fuel pump and filter...
  13. B

    Another "Wally" on eBay........

    http://cgi.ebay.com/ebaymotors/Mercedes-6-9-Hydrolic-Suspension-Leveling-Valve_W0QQcmdZViewItemQQ_trkparmsZ39Q3a1Q7c66Q3a2Q7c65Q3a1Q7c240Q3a1318QQ_trksidZp3286Q2ec0Q2em14QQhashZitem320313174324QQitemZ320313174324 Even spells "hydraulic" wrong and expects this price????????????????
  14. B

    Mallala come and try photos.

    http://s103.photobucket.com/albums/m125/Bandolero318/?action=view&current=7458.jpg http://s103.photobucket.com/albums/m125/Bandolero318/?action=view&current=7606.jpg http://s103.photobucket.com/albums/m125/Bandolero318/?action=view&current=7444.jpg Yes, that's oil smoke from the valve stem...
  15. B

    A good time at the Mallala sprint racing.

    Some of us Merc Club members (South Australia) went to Mallala on Saturday because the Marque Club who organises the sprint racing conducted a "Come and try" day. There was a Finnie, a 450SLC and two 6.9s. (Mine and Andreas'.) (There was a VH Commodore owned by one of our members as well, but...
Top