6.9 ride height

[aussie 6.9]

I have just fitted a reco front level valve and would like to get front and rear height set at the correct levels. I have seen them somewhere but does anybody know what they are? I measure from the ground to the bottom of the wheel arch. I currently have it set at about 62 cm

 

[Oversize]

I wish I could help but most of mine are on blocks! Have you tried searching the site?

 

[aussie 6.9]

Thanks for that. I found apost by Styria and it looks like 66 front 64 at the back should be okay.

 

[Oversize]

It’s a good idea to measure hub centre to top of arch to eliminate tyre variations including pressure, temperature, wear & mods.

 

[6.9forever]

Hub centre to top of arch:
Rear 350 mm
Front 340 mm

 

[aussie 6.9]

Thanks everybody for the info. Regards Mark.