Recent content by QLD6point9

Hi guys, I believe I’ve finally restored what I think is the correct hose routing for the windscreen and headlight washer systems, but I’d like to confirm a few things. I currently have one elbow fitting on top of the washer bottle feeding the windscreen washer pump, and the other elbow...

G’day all, Today’s task was removing the rear axle shafts to replace all of the CV boots. One of the boots had torn, so I decided it made sense to replace all of them while everything was apart. The reason for this post is to hopefully help anyone who finds themselves struggling to remove...

I would like to thank you Styria for your originating thread, which addresses the central locking system of w116 chassis vehicle. It is by utilizing this post thread that I was able to address matters pertaining to function of my central looking system on my 6.9. I now have a fully functioning...

This was a weeklong process, the mast was frozen solid with corrosion internally. The tension wheel which contacts the nylon smooth flexible cable was also corroded and seized. The internals of the antenna motor were removed from the metal housing of the antenna and we were disassembled...

After 47-48 years of sustained use the key barrel for the vehicles ignition was in a state where it was not fit for correct function. Due to the key and corresponding lock leaves wearing throughout the course of time. The end result was a barrel which had leaves that were not recessing enough...

A another task that I’ve completed today is the calibration/alignment of the door clothes position in respect to it being flush with the surrounding body work. This was quite a simple task relatively, it was achieved by repositioning the door striker assemblies on the pillars of the vehicle...

Good evening guys It’s been awhile since my last post, unfortunately life has been getting in the way. I’ve managed to get back out to my property and I’ve been continuing the Ever growing project which is my 1978 6.9. In this most recent week, my attention and efforts has been directed...

Hey there c107, The problem appears to be solved!. I do actually have a gauge set (I used it alongside the Bosch diagnosis manual to identify I had a blockage in the return line when I purchased the car). After that scenario was resolved by the gauge tests, I now swear by my gauge and trusting...

Good afternoon guys, Marcel (a custom decal/sticker producer - specifically MB stuff) in the Netherlands made me up some custom fuse charts for the 6.9 AUS market vehicle I own. I imagine Marcel now has a blueprint of this chart as it’s been produced once for my vehicle. The results came out...

John, I just want to chime in again and say good work on your behalf for using your brain to find a similar part and make alterations to achieve a result that looks almost identical to the original. Good work! James

Hey there guys and girls, Just hoping for perhaps an easy answer here as opposed to diving back into the Bosch Kjet diagnosis manual (having been through the process before). Story is, 6.9 that I own has all of a sudden (after previously working perfectly) presented with an issue whereby cold...

Just wanting to revive an old topic that has also been covered in here I see. Diaphragms for the door locking mechanisms/actuators are still available from this chap. I have just ordered 12 for my 6.9. Performance analysis co - George Murphy https://www.perfanalysis.com/ For us Australian...

Just wanting to share my experience with custom decal reproduction by a chap in the Netherlands who runs a business named Marcel. Absolutely brilliant job on this reproduction. I managed to buy all of the other applicable decals/stickers for my 6.9. However this particular one (not sure if this...

A while back I was contemplating a conversion to EFI from Kjet, (for my m100.985 6.9) A crowd in Poland had kits for various other Kjet MB engines (m110 and a few others). They hadn't yet delved into the m100 series engines and wanted me to provide measurements for distancing between...

Good afternoon guys, Wanting to advise that I have made contact with a local 3D printing company in Brisbane Australia that specializes in recreating classic vehicle components out of various forms of material. I am going to be taking my intact (however fragile) RHD washer bottle down to this...